I was about ready to attach this NACA vent when I realized that cut the hole to the contour of the vent. The fuselage side is supposed to cover the round opening. Now I have to come up with a suitable patch.
skip to main |
skip to sidebar
A beautiful RV10 at Oshkosh 2009
Empennage Complete
N116EX
Posts
Total Pageviews
About my blog
- Sean
- Fort Worth, Texas, United States
- This blog is going to be a little different from most of the amateur built aircraft web sites. There are many RV10 builder sites out there that are very detailed with tons of good technical information. My site is going to take a different approach. I am going to document the construction process with real time uploads from my iPhone. I will be posting photos as I progress, and will probably elobrate on them when I have time.
A beautiful RV10 at Oshkosh 2009
Empennage Complete
Blog Archive
-
▼
2011
(69)
-
▼
May
(12)
- Stiffness, drain flange, and fuel cap flange insta...
- Took a break to go flying this morning.
- Everything ready for prosealing tank stiffners tom...
- End ribs. Fittings, plugs prosealed in place
- Right tank ready for final assembly.
- Here is the finished product.
- Here are the steps so for.....
- Ready to attach
- Almost cut out
- Using nibbler to remove material
- Drilling pilot hole
- NACA vent template
-
▼
May
(12)
No comments:
Post a Comment